gassero GSR-11-PL, Инструкция по установке и эксплуатации

Страница: 4 / 19

3
► High Efficiency
With a COP value up to 5.5, our heat pumps are very efficient when transferring heat from the air to the
swimming pool water. With the heat pump technology, as much as 80% of cost compared to an electrical
heater can be saved.
► Long Life-Span
The heat exchanger is made of PVC & Titanium tube, which can withstand and prolong exposure to
swimming pool/pond water.
► Easy Control and Operation
The unit is very easy to operate: simply switch it on and set the desired pool water temperature. The system
includes a micro-computer controller, allowing all operation parameters to be set. Operation status can be
displayed on the controller with LCD display.
► Excellent components
High quality Japanese brand compressor: Mitsubishi, Toshiba, Sanyo compressor with green gas R410A,
achieving higher performance of heat exchanging.
Durable and reliable Titanium heat exchanger, which can resist chloride ion corrosion in the water;
hydrophilic fin-tube evaporator, inbuilt threaded pipe, which provides good performance in water skiing and
anti-defrost.
2. Safety Precautions
Attention!
It is required to read the Safety precautions in detail before operation. The precautions
listed below are all-important for safety, please obey without fail.
2.1 General
1) Before install the heat pump, please confirm the local power supply is in accordance with the requirement
of the heat pump, refer to the Technical data and the Wiring diagram provided in this manual.
2) Connecting the heat pump to a ground wire is necessary, in order to prevent electrical shock caused by
an unexpected short circuit inside the unit.
3) Please install the electrical protection devices, according to the local regulations.
4) The heat pump must be installed on reliable base or supporting framework.
5) If the heat pump is installed on the floor, its base or supporting framework should be heightened, to avoid
ingression of accumulated water in rainy season. In snowy areas, it is important to prevent accumulated
snow from blocking up the air-out. The recommended height is 20cm to 30cm.
6) Install the drainage pipe before fix the heat pump to the ground. There are two drainage hole on the heat
pump base, which could be connected to the drainage pipe with a pipe arches which contains in spare
parts.
7) Drain ditch or other facilities should be arranged under the heat pump, to avoid the environment influence
because of water discharge.
8) Ensure the unit is well ventilated, direction of air exhaust is kept away from windows of neighboring
buildings, and the exhaust air cannot flow back. Moreover, adequate service clearance should be kept
around the unit.
9) DO NOT put fingers or sticks into the ventilative fan.
10) The unit should not be installed at places accompanied with oil, inflammable gas, corrosive
components e.g. sulfur compound, or high-frequency equipment.
11) The heat pump is usually placed next to a house, which gives a directed sound distribution that should
be considered, so it should take proper action to reduce the noise impact.