Gason 5030 Series, Руководство оператора

Страница: 25 / 80

GENERAL MAINTENANCE
Page 21
07/13
General Maintenance
Introduction
Regular maintenance will ensure
trouble free operation for the life of the
spreader. It is recommended that when
replacing parts you use genuine
components and fasteners of the same
grade as the original machine.
DO NOT COMPROMISE SAFETY WITH
FAULTY COMPONENTS
Daily Check list
1. Keep the machine as clean as possible.
2. Grease gearbox gear selector pin on a
daily basis. Ensure that the gear selector
pin has been fully pushed in before
greasing the nipple at the end of the pin.
Fig. G28 Selector pin ready for greasing.
3. Check that the shear bolts on the drive
shaft are all in place and functional.
4. Check main feed chain for damage and
that it turns freely at the jockey wheel.
This is best done when the spreader is
empty and in low or medium gear.
5. Check hydraulic system for leaks or
damaged hoses.
Weekly Checklist
1. Check all wheel nuts are tight weekly or
after transportation (refer page 6).
2. Grease all gearbox bearings and top
selector pin (gear ratio selector). Ensure
that the selector pin is fully pushed in
before pumping grease into the grease
nipple on the end of the pin.
3. Grease all driveshaft bearings at the rear
of the spreader.
4. Grease the bushes on the front and rear
idler shafts under the feed chain.
5. Check that the feed chain tension springs
at the front of the spreader is operating
within its range.
Fig. G29 Feed chain tension spring.
6. Check spinners for physical damage and
that the wear pads are fastened correctly
to the fins.
Fig. G30 Spinners and wear pads.