3
2
Gas Installation Codes
• Appliances must be used in accordance with the
installation requirements of your gas supply
authority, or the Australian Standard AS 5601.
• Appliances for use with bottled gas are labelled
‘propane gas’.
Clearances
Minimum Clearances from combustible materials
must be:
Rear - 350mm Sides - 300mm Above - 600mm
Hose & Regulator Safety
The regulator and hose assembly supplied with the
appliance are suitable for propane gas only.
A gas regulator adjusted to have an outlet
pressure of 2.75kPA is supplied for connection to
the propane gas cylinder. The pressure regulator
and hose assembly supplied with the appliance
must be used. Replacement pressure regulators
and hose assemblies must be those specified by
the appliance manufacturer.
When connecting the hose and regulator assembly
to the gas cylinder, take care to avoid unnecessary
twisting or kinking of the flexible hose.
After the assembly has been secured, turn on the
gas and check for leaks by brushing a soap and
water solution over all connections.
If you are unable to correct the leak by tightening
the connections, turn off the gas and contact the
supplier immediately.
Always ensure the appliance is kept away from
flammable materials and the gas cylinder clear
of any heat source. When changing over from
an empty gas cylinder to a full one make sure
this procedure is carried out in a flame free
atmosphere.
Gas Cylinder Use & Safety
This is a low pressure appliance and must only be
used with the hose and regulator supplied. It is
designed for use with 9Kg propane gas cylinders
certified to AS 2469.
The cylinder should be filled by a reputable gas
supplier and visually inspected and re-qualified at
each filling.
Always keep cylinder in an upright position.
GENERAL INFORMATION
CONTENTS
Section
Page
General information
2-3
General assembly
4
Lighting procedure
4
Operating procedure
5
Care and maintenance
5
Important safeguards
6
Service and safety
7
Operating instructions
7
Electrical data
7
Assembly instructions
8-10
Natural gas conversion
11
Safe appliance locations
12
Side clearances of 300mm must
be maintained to allow adequate
airflow for combustion.
Rear clearance of 350mm must be maintained
to avoid overheating surrounding surfaces.
For any queries or assistance call
Customer Service
Australia Only
1300 174 876
Hours of operation:
Monday to Friday 8.30am - 5.30pm EST
Do not return to place of purchase.
Keep your purchase receipt, this will be
required to make any claims under the 12
month warranty.
