2
3
READ ME FIRST
GAS LEAK TESTING
It is important that you leak test the BBQ before first use and every time the gas cylinder
is refilled and reconnected to the BBQ.
To Complete Leak Test
• Make sure the control knob is OFF.
• In a small container, mix up a solution of water and detergent/soap.
• Mix the solution well (about the same concentrate as washing up water).
• Turn the cylinder ON by rotating the knob to open position.
• Using a brush or spray bottle apply the soap solution to the gas line and each join
in the gas line including:
- the gas connection at the inlet of the BBQ
- all gas hose connections
- the gas connection at the gas cylinder
• If bubbles appear, there is a gas leak.
• If the leak is at the connection, re-tighten and re-seal.
• If the leak is anywhere else or you cannot resolve the leak by tightening
the connection DO NOT PROCEED.
• Replace gas hose and regulator.
• Replacement hose and regulators can be purchased from your local BBQ retail specialist.
DO NOT USE NAKED FLAME FOR LOCATING GAS LEAKS.
IF A LEAK PERSISTS, CALL AN AUTHORISED PERSON.
1. Add soap and water to spray bottle or soapy water with brush.
2. Turn off gas valves.
3. Turn gas cylinder on.
4. Spray or apply soapy water
on gas connections.
5. If leak is present,
bubbles will appear.
+
OFF
HIGH
LOW
SOAP
WATER