Gasmate NOMAD1, Инструкция по эксплуатации, Страница: 11 / 16

11 10
GENERAL INFORMATION
CONNECTING & DISCONNECTING
TO GAS SOURCE
Familiarise yourself with the general information and
safety guidelines located at the front of this manual.
Check
1. Gas cylinder is filled. A sloshing sound will be heard
when shaken.
2. The burner control is in the ‘OFF’ position
Connecting
1. Ensure valve is in OFF position.
2. Check for any damage to the cylinder connection.
3. Attach the regulator to the cylinder valve.
4. Use a soapy water solution to check the joint. If
bubbles appear the connection will need to be re-
tightened.
Regulator Safety Feature
All QCC regulators (the part that attaches to the gas
cylinder to regulate the flow of gas) have a safety feature
included that restricts gas flow in the event of a gas leak.
You can inadvertently activate this safety feature without
having a gas leak. This typically occurs when you turn on
the gas using the barbecue control knob before you turn
on the gas cylinder valve.
If the gas regulator safety feature activates, the barbecue
will operate with reduced output as gas flow is restricted.
These steps should be taken first to reset the gas
regulator safety device:
1. Ensure the barbecue hood is open.
2. Turn gas cylinder valve off.
3. Turn off all control knobs.
4. Disconnect the regulator from the gas cylinder.
5. Wait 30 seconds.
6. Reconnect the regulator to the gas cylinder.
7. Leak test the connection using a soapy water solution.
Ensure no bubbles appear before proceeding.
8. Slowly open the gas cylinder valve all the way. Do
not put excessive force on the valve at the full open
position, to avoid damaging the valve.
9. Light barbecue as per the instructions provided.
LIGHTING PROCEDURE
Burner Operation & Ignition System Check
1. Open the hood of the barbecue before attempting to
light the burner.
2. Turn the control knob clockwise to “OFF” position.
3. With cylinder valve in ‘CLOSE’ position push and turn
the control knob to HIGH. Check for sparking to the
burner.
4. If spark is not evident at the burner ignition point,
check that the ignition lead is firmly attached to the
control and sparker tip.
5. With sparking established turn the cylinder valve to
‘OPEN’.
6. Push and turn control knob anti-clockwise to ‘HIGH’.
7. If the burner fails to ignite after several attempts turn
off gas supply at cylinder valve and the control knob
off (clockwise). Wait five minutes before attempting to
relight with ignition sequence.
8. Following successful ignition, adjust the heat by
turning the control knob to the “HIGH”/”LOW”
position.
9. To turn the barbecue ‘OFF’ turn the cylinder valve to
the ‘CLOSE’ position, then turn the control knob on
the barbecue clockwise to the ‘OFF’ position.