4
ASSEMBLY INSTRUCTIONS
Note:
Remove any transit protection material.
Tools Required:
Phillips head screw driver and 2
adjustable spanners.
Step 1
Attach the wheel assembly to the base with two
M8 x 16mm bolts and nuts.
Step 2
Attach the brackets onto the base with four M8 x 16mm
bolts, then attach the cylinder cover with eight
M5 x 10mm screws and nuts.
Step 3
Place the burner head on the cylinder cover and secure
with four M4 X 8MM screws.
Step 4
Position the mesh guard around the burner with the lift
up door in front of the control knob locating the wire pins
into the cylinder cover holes then secure with the wing
nut on top.
Step 5
Attach the handle on the same side as the wheels, using
two washers and M6 nuts.
Step 6
Attach the hose and regulator to the underside of the
burner head, tightening the hose fitting thread firmly.
Leak test this connection with a soapy water solution
before attempting to light the heater.
PARTS LIST
Name
QTY
Mesh Guard
2
Burner Head
1
Handle
1
Cylinder Cover
1
Hose and Regulator
1
Wheel Assembly
1
Base
1
Base Brackets
4
Wing Nut
1
M8 x 16mm Bolt
6
M8 Nut
2
M6 Washer
2
M6 Nut
2
M5 x 10mm Screws & Nuts
8
M4 x 8mm Screws
4
WHEEL
ASSEMBLY
BRACKETS
BASE
WING NUT
BURNER
HEAD
CYLINDER
COVER
HOSE AND
REGULATOR
HANDLE
