4
GAS INSTALLATION CODES
• Appliance must be used in accordance with
the installation requirements of your gas supply
authority, or the appropriate installation code issued
by Standards Australia AS 5601.
• Appliances for use with bottled gas are labelled
‘propane gas’.
• Only use on a non-combustible surface.
CLEARANCES
Minimum Clearances from combustible materials
must be: Cylinder - 500mm
Wall - 500mm
Above - 1200mm
Below - never use on a flammable surface.
Only use on a non-combustible surface.
Gas connection is 3/8” SAE
HOSE & REGULATOR SAFETY
The regulator and hose assembly supplied with the
appliance are suitable for propane gas only.
The pressure regulator and hose assembly supplied
with the appliance must be used. Replacement
pressure regulators and hose assemblies must be
those specified by the appliance manufacturer.
Only use the hose assembly supplied with this
appliance for direct connection to the cylinder
“DO NOT USE ADAPTORS”. Check the regulator
“O” Ring periodically for wear or damage and
replace if required.
When connecting the hose and regulator assembly
to the gas cylinder, take care to avoid unnecessary
twisting or kinking of the flexible hose. Maximum hose
length is 1 metre.
After the assembly has been secured, turn on the gas
and check for leaks by brushing a soap and water
solution overall connections.
DO NOT USE this appliance if it is leaking, damaged
or does not operate properly.
If you are unable to correct the leak by tightening the
connections, turn off the gas and contact the supplier
immediately.
Always ensure the appliance is kept away from
flammable materials and the gas cylinder clear of
any heat source. When changing over from an empty
gas cylinder to a full one make sure this procedure
is carried out in a well ventilated location, preferably
outside, away from people and away from any sources
of ignition; such as naked flames, pilot flames, electric
heaters/equipment.
GENERAL INFORMATION
SPECIFICATIONS
Appliance specifications can be found on the data label
attached to the appliance body.
GAS CYLINDER USE & SAFETY
This is a low pressure appliance and must only be used
with the hose and regulator supplied. This appliance
shall only be used with propane gas cylinders certified
to AS 2469. It may be hazardous to attempt to fit other
types of gas containers.
The gas cylinder should be filled by a reputable gas
supplier and visually inspected and re-qualified at
each filling.
Always keep cylinder in an upright position. Always
close the cylinder valve when the appliance is not
in use.
Do not subject gas cylinder to excessive heat.
GAS INSTALLATION CODES
• Appliance must be used in accordance with
the installation requirements of your gas supply
authority, or the appropriate installation code issued
by Standards Australia AS 5601.
• Appliances for use with bottled gas are labelled
‘propane/ULPG gas’.
• Only use on a non-combustible surface.
NEVER STORE YOUR GAS
CYLINDER INDOORS
If you store your appliance indoors, ALWAYS
disconnect the gas cylinder first and store the cylinder
safely outside. Cylinders must be stored outdoors in
a well ventilated area out of reach of children, and
must not be stored in a building, garage or any other
enclosed area.
LOCATION OF YOUR APPLIANCE
Only use on a non-combustible surface. DO NOT
use your appliance in garages, porches, sheds,
breezeways, or other enclosed areas. Your appliance
is to be used OUTDOORS ONLY. The appliance is not
intended to be installed in or on recreational vehicles
and/or boats and should not be placed on any surface
that will burn. Do not obstruct the flow of combustion
and ventilation air around the appliance.
