GENERAL ASSEMBLY
Connecting & Disconnecting to the Gas Source
Familiarise yourself with the general information and safety guidelines located in this manual. Note: Remove any transit
protection material.
ASSEMBLY
Review the contents of the package. Make sure all listed components are included.
1. Install the burner and heat reflector into the steel frame, using the wing nut.
CONNECTION
1. Check that the cylinder is filled, a sloshing sound will
be heard when shaken.
2. Connect the Regulator to the cylinder valve and
tighten (See Pic. A).
3. Connect hose to gas control and tighten with a
spanner - take care not to overtighten (See Pic. B).
4. Check for any damage to either the cylinder
connection or the hose. NEVER attempt to use
damaged equipment.
5. Turn the gas cylinder valve on and spray soapy
water on all connections to check for leaks. If a leak
is detected turn the valve off, retighten all connections
and retest.
5
2. Align the Burner Tube Cover with the gas control assembly positioned at the end of the burner and then secure with
the Wing Nuts.
3. Attach the LP Gas hose to the Gas Valve Assembly using a spanner – Do Not Over Tighten.
A
B
