Gasmate BQ1070, Инструкция по эксплуатации, Страница: 17 / 20

17 16
GENERAL ASSEMBLY
CONNECTING & DISCONNECTING
TO GAS SOURCE
Familiarise yourself with the general information and
safety guidelines located at the front of this manual.
Check
1. Gas cylinder is filled. A sloshing sound will be
heard when shaken.
2. The burner control is in the ‘OFF’ position.
Connecting
1. Ensure valve is in OFF position.
2. Check for any damage to the cylinder connection.
NEVER attempt to use damaged equipment.
3. When connecting the hose to the cylinder tighten the
nut to a positive stop by hand or spanner.
4. Open cylinder valve fully. If a leak can be heard at
either end of the hose turn cylinder off and tighten
joint. Wait 5 minutes before re-testing and use a soapy
water solution to check the joint. If bubbles appear the
connection will need to be re-tightened.
Disconnecting
1. Ensure the burner control is in the ‘OFF’ position.
2. Ensure the gas cylinder is in the full OFF position.
3. Detach the hose from cylinder.
IMPORTANT
• IMPORTANT: Before connecting and
disconnecting barbecue to gas source, make
sure burner controls are in ‘OFF’ position.
• CAUTION: When the barbecue is not in use, the
gas must be turned off at the cylinder.
• Check that the seals between the appliance
and the gas cylinder are in place and in good
condition before connecting the gas cylinder.
• Do not use this appliance if it has damaged or
worn seals.
• NOTE: If for some reason, ignitor fails to produce
a spark at the electrode, BBQ can be lit by a long
BBQ match. With hood open insert ignited match
into burner lighting hole positioned on the right
hand side of the BBQ body (underneath side
shelf). Push and turn the far right control knob to
HIGH. Burner ignition can be checked through
this hole. Subsequent burners will cross light.
• Check performance of burner prior to installing
BBQ plates.
• Do not smoke when attempting to ignite BBQ.
• Never use volcanic rock, heat beads or other
material.
• Always use protective gloves when handling hot
components.
LIGHTING PROCEDURE
Burner Operation & Ignition System Check
1. With cylinder valve in ‘OFF’ position push and rotate
the control knobs. Check for sparking to the burners.
2. If spark is not evident at the burner ignition point,
check for any loose leads at either the electrode or
the gas valve.
3. Push and turn anti-clockwise to HIGH the control
knob.
4. The side burner cover must be open before pushing
and turning the control knob anti-clockwise to HIGH.
5. If the burner fails to light after several attempts turn
off the gas supply and inspect for any obstructions to
the gas flow.
If re–ignition is necessary while the gas barbecue is still
hot, you must wait for a minimum of 5 minutes before
commencing to re–ignite (this allows accumulated gas
fumes to clear).