4
BRACKETS
BASE
WING NUT
BURNER HEAD
CYLINDER
COVER
HOSE AND
REGULATOR
MESH GUARD
Tools Required
Phillips head screwdriver
2 Adjustable spanners
Note: Remove any transit protection material
STEP 1
Attach the brackets onto the base with four M8 x 16mm
bolts, then attach the cylinder cover with eight
M5 x 10mm screws and nuts.
STEP 2
Place the burner head on the cylinder cover and secure
with four M4 x 8mm screws.
STEP 3
Position the mesh guard around the burner with the lift
up door in front of the control knob locating the wire pins
into the cylinder cover holes then secure with the wing
nut on top.
STEP 4
Attach the hose and regulator to the underside
of the burner head, tightening the hose fitting thread
firmly. Leak test this connection with a soapy water
solution before attempting to light the heater.
PARTS LIST
NAME
QTY
Mesh Guard
2
Burner Head
1
Cylinder Cover
1
Hose and Regulator
1
Base
1
Base Brackets
4
Wing Nut
1
M8 x 16mm Bolt
6
M8 Nut
2
M5 x 10mm Screws & Nuts
8
M4 x 8mm Screws
4
AREA HEATER ASSEMBLY
