Frequently asked questions
If you did not get the results you expected, we hope to address your
questions and problems with the following:
Why do the LEDs of the level indicator not light up?
+ Check to make sure the 12-volt LED display is supplied with power.
+ Check to make sure that the 3-meter line is correctly connected to the LED
display.
Why can the fill level not be determined correctly with the level indicator ?
+ Remember that a gas cylinder may only be filled to a capacity of 80 % for
safety reasons.
+ Do not place the level indicator onto rusty areas, the weld, or uneven
surfaces.
+ Do not pull the level indicator downward along the cylinder; rather lift each
time before placing it in a new position.
+ Clean the cylinders with the aid of silicone spray.
Frequently asked questions
Why do the red and green LEDs in the level indicator light up alternately
when I am trying to determine the fill level?
+ Make sure that the level indicator lies flat against the cylinder.
Why does the green LED not light up on the LED display?
+ Check to see if the 12-volt LED display is being supplied with power.
Technical data
External reserve indicator for gas cylinders
Item number
GL-4001
Dimensions of indicator (LxWxH)
75,4 mm x 30,9 mm x 17,8 mm
Dimensions of display (LxWxH)
54,0 mm x 54,0 mm x 9,0 mm
Weight indicator
30 g
Weight display
10 g
Approval mark:
GB
24
よくある質問
ディスプレーに12Vは来てますか？
ディプレーと3mコードで正しく接続されていますか？
インディケータのLEDが点灯しない
ガスのレベルがうまくわからない
ガスのレベルは安全上の理由で80％となっています
インディケータがサビや溶接部に付いている
インディケータはボンベの上を引きずらず、離しながらレベルを探ります
必要に応じシリコンスプレーでボンベ表面をきれいにして下さい
赤と緑のLEDが交互につく
インディケータはボンベにフラットに当たっていますか？
ディスプレーが緑にならない
ディスプレーに12Vがきていますか？
