e. Install two “D” cell batteries (included) in the compartment on the bottom of the
appliance. Check the batteries are facing the correct direction.
f. Ensure the ignition switch located on the bottom of the appliance is turned to the
“on” position.
g. This appliance shall only be used with a butane or propane or butane/pro pane
mix refillable gas container certificated to AS2030.1.
h. Use shifting spanner to connect the gas inlet connector (Picture 5) and water
inlet connector (Picture 6) before install gas supply line and water inlet hose to
the appliance. Attached the flexible hose and regulator to the “Gas inlet”
(Picture 7). Do not over tighten. Over tighten may causing a gas leak! Ensur
that you use supplied washers (Picture 8-10) on all connectors and check for
any gas smell before ignition as instruction. Make sure the gas inlet connector
and water inlet connector are screwed all the way on.
i. Connect the other end of the flexible hose and gas regulator to the gas container.
Hand-tighten the connection in an anti-clockwise direction. Do not place the gas
container directly beside or above the appliance.
j.
Connect the supplied shower head and flexible hose. Make sure to insert the
supplied washer at the water outlet connection (Picture 11). After that, connect
with the brass part at the bottom of the appliance marked “Water outlet” (Picture
12), the last step is use the shower fast connector(Picture 13) connect with the
water outlet connector(Picture 14).
Caution
Make sure the shower head direction is not face to the appliance during showering,
to avoid the flameout problem.
Picture 5
Picture 6
Picture 7
Picture 8
Picture 9
Picture 10
12