Gasboy Islander ICR PLUS, Руководство по установке

Страница: 44 / 146

2-4.2. Conduit Requirements
Conduits must comply with:
•
All conduits must be made and installed according to local regulations.
•
High-voltage AC and low-voltage DC must NOT be combined in a common conduit,
junction box or wire through.
•
RS-485 or LAN communication must not exceed 330 feet (100 m). Cables must be
inserted in a separate low voltage conduit, away from AC wires. Communication
range can be extended with 3rd party devices.
•
RS-232 communication must not exceed 50 feet (15 m). RS-232 communication
shielded cable must be inserted in a separate low voltage conduit, away from AC
wires. Communication range can be extended with 3rd party devices.
•
Antenna wire must not exceed 330 feet (100 m) in case the VIU is in use, and 50 feet
(15m) in case the FuelOpass is used. Antenna wire must be inserted in a separate
low voltage conduit, away from AC wires.
•
All conduits must be inserted in the Islander PLUS pedestal through the holes and
knockouts provided in the lower protective plate (see Figure 2-1). Do not make any
other hole in this unit. If you must make holes at locations other than those provided,
contact Gasboy for approval.
•
After completing the installation, all open holes should be sealed.
2-4.3. Conduits at Islander PLUS
Islander PLUS includes a protective plate below the Terminal Block in the installation pole. The
plate is perforated with circles that enable to insert four conduits (see Figure 2-1, Figure 2-2):
•
Four conduits of 1" diameter
•
Four conduit of 1/2" diameter
The conduits are in use for:
•
Two conduits of 1" diameter are intended for high voltage cables
•
One conduit of 1" is intended for low voltage conduit
The cables and wires to/from the other units in the forecourt are connected to the Terminal Block.
The cables and wires are inserted through the conduits in accordance with their types and routed to
their sources.
Islander PLUS Manual
30