SERVICE WORK ON THE CHASSIS 11
67
S04555-10
Main work
–
Check throttle cable routing.
The throttle cable must be routed along the back of the handle-
bar, to the right of the frame, above the fuel tank bracket, and
to the carburetor. The throttle cable must be secured on the fuel
tank bracket with a rubber strap.
» If the throttle cable routing is not as specified:
–
Correct the throttle cable routing.
Finishing work
–
Install the fuel tank.
–
Mount the seat. (
11.41
Checking the rubber grip
401197-01
–
Check the rubber grips on the handlebar for damage, wear, and
looseness.
Info
The rubber grips are vulcanized onto a sleeve on the left and
onto the handle tube of the throttle grip on the right. The
left sleeve is clamped onto the handlebar.
The rubber grip can only be replaced with the sleeve or the
throttle tube.
» If a rubber grip is damaged or worn:
–
Change the rubber grip.
102245-10
–
Check that screw
1
is firmly seated.
Guideline
Screw, fixed grip
M4
5 Nm (3.7 lbf ft)
Loctite
®
243™
Diamond
A
must be located at the top.
