Garrick BS712, Инструкция по эксплуатации

Страница: 3 / 20

12. Secure work
-Where possible use clamps or a vice to hold the work. It is safer than using your hand.
13. Do not overreach
-Keep proper footing and balance at all times.
14. Maintain tools with care
-Keep cutting tools sharp and clean for better and safer performance.
-Follow instructions for lubricating and changing accessories.
-Inspect tool cords periodically and replace if damaged.
-Keep handles dry, clean and free from oil and grease.
15. Disconnect tools
-When not in use, before servicing and when changing accessories such as blades, bits and
cutters, disconnect tools from the power supply.
16. Remove adjusting keys and wrenches
-Form the habit of checking to see that keys and adjusting wrenches are removed from the tool
before turning it on.
17. Avoid unintentional starting
-Ensure switch is in “off” position when plugging in.
18. Use outdoor extension leads
-When the tool is used outdoors, use only extension cords intended for outdoor use and so
marked.
19. Stay alert
-Watch what you are doing, use common sense and do not operate the tool when you are tired.
20. Check damaged pans
-Before further use of tool. It should be carefully checked to determine that it will operate
properly and perform its intended function.
-Check for alignment of moving parts, binding of moving parts, breakage of parts, mounting
and any other conditions that may affect its operation.
-A guard or other pan that is damaged should be properly repaired or replaced by an authorized
service center unless otherwise indicated in this instruction manual.
-Have defective switches replaced by an authorized service center.
-Do not use the tool if the switch does no turn it on and off.
21. Warning
-The use of any accessory or attachment other than one recommended in this instruction
manual may present a risk of personal injury.
22. Have your tool repaired by a qualified person
-This electric tool complies with the relevant safety rules. Repairs should only be carried out
by qualified persons using original spare parts, otherwise this may result in considerable
danger to the user.
23. Never stand on tool. Serious injury could occur if the tool is tipped or if the cutting tool is
accidentally contacted.
24. As to the power supply, the error of the voltage should be /- 10% V, the rate error
should be /- 1Hz.
25. Operating condition.