Garrick BS712, Инструкция по эксплуатации

Страница: 11 / 20

2. Place machinist’s square on table next
blade as pictured in Fig.11.
3. Check to see blade makes contact with
square along the entire width of the blade.
4. If adjustment is necessary, loose bolts (A,
Fig.11) and rotate blade guide assemblies
slightly in the same direction until blade
makes contact with the square along it’s
entire width.
5. Tighten bolts (A).
6. Connect machine to the power source.
Note: If adjustment to square blade to table is
necessary, be sure to check blade adjustments
again.
Adjusting Blade Square to Vise
1. Disconnect machine from the power
source.
2. Place a machinist’s square as pictured in
figure 12 square should lie along entire
length of vise and blade without a gap.
3. If adjustment is necessary, loosen bolts
holding vice and adjust vise so that square
lines up properly. Tighten bolts.
4. Connect machine to the power source.
Adjusting Blade Tracking
★
WARNING
：
Blade tracking adjustment
requires running the saw with the back
cover open. This adjustment must be
completed by qualified persons only!
Failure to comply may cause serious
injury!
Note: Before making any tracking
adjustments, try a new blade. Warped blades
will not track.
Blade tracking has been set at the factory and
should not require adjustment. If a tracking
problem occurs, adjust the machine as
follows:
1. Move saw arm to the vertical position and
lack in place by shutting off the hydraulic
cylinder valve.
2. Confirm that blade tension is set properly.
To adjust, see section titled “Adjusting
Blade Tension”.
3. Open back cover by loosening lock
screws.
4. Run saw and observe blade. Blade should
run next to but not tightly against wheel
flange.
5. Loosen bolts (A, Fig.13).
6. Turn set screw (B) while observing blade
tracking on wheel. Turn set screw
clockwise to track blade closer to the
wheel flange. Turn set screw
counter-clockwise to track blade away
from the wheel flange.