You will find batteries beneath a protective
clamp directly behind the control panel.
Loosen the screw holding it and slide this
clamp off the batteries to remove them as
shown in the photograph. Make certain
new batteries are installed properly and
securely, but do not force. Always handle
the chassis gently, using care not to
place stress on any wires. Keep it clean
and free of moisture, sand or dust. During
reassembly, make certain that all parts
and wires fit snugly, but do not force.
BATTEriES
The Scorpion Gold Stinger requires three
9-volt batteries. When replacements are
necessary, use only high quality carbon,
alkaline or NiCad rechargeable batteries.
Battery Test
Each time the detector is turned on;
the batteries that power its circuitry are
checked automatically and audibly. Three
or four tones indicate that the batteries
are very good; two tones, adequate; and
single or no tone, replace the batteries.
Battery replacement
The batteries are located on the side of
the chassis of your Gold Stinger inside
its control housing. To reach them, first
disconnect the searchcoil cable and
remove the control housing from the stem
by pressing the snap locks. Then, loosen
by hand (never use tools) the thumbscrew
beneath the control housing. Press on
the searchcoil connector to loosen the
chassis and carefully slide it out.
Содержание Scorpion gold stinger
Страница 1: ...TM TM ...