Garrecht Avionik GmbH
VT-01 Transponder
User manual
Dokument 01.0200.10E
Revision: 1.3
7
13.02.07
2. Switching on and off
Press the On/Off key shortly to switch on the unit.
After the system start, the screens shown below are
displayed.
If the system power is interrupted shortly (less than 10
seconds.), the unit restarts in a quick boot mode and
continues operation within 1 second. In this case the
screenshots shown below will be skipped automatically.
Start screen showing system name and
manufacturer
Information about Steering unit (=CPNL)
•
S/N = Serial number
•
HW = Hardware release
•
SW = Firmware release
Entered Mode-S Adress (hex format)
Note: If no Mode-S Adress has been entered,
confirm the Messages below by pressing any
key except ON/OFF
This screen will be shown only, if no Mode-S
address has been entered. Confirm it by
pressing any key except ON/OFF.
This screen will be shown only, if no Mode-S
address has been entered. Confirm it by
pressing any key except ON/OFF.
N
e
xt
p
a
g
e
:
w
a
it
f
o
r
3
se
co
n
d
s
o
r
p
re
ss
a
n
y
ke
y
Main screen of the operating system after
performing self tests and showing all the
screens above. When switched on manually
or after power interruption greater than 10
seconds the system is set to the Standby
(SBY) mode always.
To switch off the system, press the on/off key and hold it for at least 3 seconds. When holding the key,
the system counts down from 3 seconds to zero. When the screen is blank, release the key.
Garrecht
VT-01
SteeringUnit
Softw.v 1.01
Mode-S Addr.
12AB34 hex
FL045 >0021
SBY 0022
Mode-S Addr.
INVALID
running in
A/C mode
