GARO GLB, Инструкция по сборке и эксплуатации

Страница: 5 / 27

8 9
EN EN Assembly instructions for fitters Circuit diagram
1. blue/brown
2. blue/red
3. blue/yellow
4. blue/green
5. white
6. red
Load balancing – reduces charging current when demand elsewhere increases
Connect central energymeter to ”E
-
Meter” modbus
terminals
(A- to A- and B+ to B+)
Config meter to modbus address
no.2
(9600 baud, no parity, one stop bit)
Config SW1 (1-3) for max current A (fuse rating)
Compatible energy meters
Garo 1-phase energymeter,
GNM1D -RS485
Garo 3-phase energymeter,
GNM3D -RS485
FUSE 2AT
Connector for
OCPP/Wi-Fi module
M
CP PP
Fuse/RCCB FB
Contactor FB
Contactor control
Line (L)
Neutral (N)
Protec ti ve earth (PE)
Connector for RFID
reader
RCCB
L N PE
L N PE
Type 2 outlet
Type 2 outlet
GK32
1 2 3 4 5 6
DataLink
E-Meter
Ext. charge control
open=on, close=o ff
*) - see info below
SW2
SW1
* Remote control signal
can be set in inverse
func
ti on.
See dip-switch SW1(4)
Remote control
A1 A2
63
64
GKN11
A -
B +
A -
B +
Max charging Factory default
current (A) 16A
Factory default
SW3
SW3
– Reset bu tt on,
Press down > 3 sec to
reset WiFi back to default
Access Point mode. See
label behind sliding front
cover for SSID name and
password
Congratulations on selecting a GARO Wallbox and contributing to a better environment.
The GARO Wallbox is an AC charger enabling Mode 3 charging which complies fully
with the requirements of IEC 61851-1 and IEC TS 61439-7.
The product complies with IP Code IP44, with a closed front.
It is to be fitted to a wall, and all installation must be carried out by an authorised fitter
and comply with local installation regulations.
Important information for fitters:
The charger must always be protected by a residual-current circuit breaker and fuse.
The three-phase charger is equipped with a residual-current circuit breaker and must be
fitted with a max 32A fuse in the supply distribution box. The single-phase charger is fitted
with a personal protective charger with a maximum 125A fuse. When load balancing,
an extra energy meter must be installed in the electrical distribution box.
Assembly instructions for fitters
(figure 4)