5
!
!
!
Rx
!
1. Click left touch area until ”Ut rAtIo” is visible.
If you need to change the Ut Ratio value, follow below instructions:
2. Longpress center touch area and PrG is visible.
3. Click left or right touch area until wanted value is visible. Confirm by longpress center touch area and next figure starts to blink.
4. Repeat step 3 until the complete value is correct.
!
!
!
Rx
NOTE! Correct Ut Ratio value is ”1” for 230/400V systems.
UT Ratio setting
6
!
!
!
Rx
!
Rx
!
Rx
Click left touch area until you see ”AddrESS”.
!
!
!
Rx
EN
8
