GARNET GAE -3030
8
?
G.Lite
?
G.dmt
This is configured by setting the BUN attribute AdslMode with the following
console command:
bun set port atm/adslmode=<mode>
Where acceptable value of
<mode>
are, t1413, glite, gdmt.
Protocol Configuration for configuring the modem for this mode of operation.
2.5 Ethernet Bridge Configuration
In the Ethernet bridge configuration, the modem bridges data between the local
Ethernet LAN and the service provider. The ADSL link must be set up in RFC1483
mode with a PVC to communicate across. The PVC is assigned by the service
provider. The bridge needs to be told about both the Ethernet interface and the
1483 interface. Since the modem is transparent, the PC’s default gateway must
be set to the service provider’s IP address.
The following configuration must be performed to set up the modem for bridge
mode:
?
Add the Ethernet device to the bridge:
Bridge device add edd
?
Add the ADSL ATM port to the bridge with RFC 1483 enabled:
Bridge device add //bun/port=atm/txvci=32/rxvci=32/rfc1483=true
?
Save the configuration and reboot the system:
config save
restart
2.6 Ethernet Router Configuration
There are multiple ways that routing can be set up depending on the
requirements from the service provider.
The following routing methods are described below:
?
IPoA Routing
