Replaceable coin cell batteries may contain perchlorate
material. Special handling may apply. See
.
CAUTION
Contact your local waste disposal department to properly
recycle the batteries.
Replacing the vívofit Device Batteries
1
Remove the module from the band.
2
Use a small Phillips screwdriver to remove the four screws
on the front of the module.
3
Remove the cover and batteries.
4
Insert the new batteries.
NOTE:
Do not damage or lose the gasket.
5
Replace the front cover and the four screws.
6
Insert the module into the band.
The device key on the module must be aligned with the key
on the band.
After you replace the device batteries, you must pair the vívofit
device with your computer or mobile device again.
Replacing the Heart Rate Monitor Battery
1
Locate the circular battery cover on the back of the heart rate
monitor.
2
Use a coin to twist the cover counter-clockwise until it is
loose enough to remove (the arrow points to
OPEN
).
3
Remove the cover and the battery.
4
Wait 30 seconds.
5
Insert the new battery with the positive side facing up.
NOTE:
Do not damage or lose the O-ring gasket.
6
Use a coin to twist the cover clockwise back into place (the
arrow points to
CLOSE
).
After you replace the heart rate monitor battery, you may need
to pair the heart rate monitor with the device again.
Device Care
NOTICE
Avoid extreme shock and harsh treatment, because it can
degrade the life of the product.
Avoid pressing the keys under water.
Do not use a sharp object to clean the device.
Avoid chemical cleaners, solvents, and insect repellents that
can damage plastic components and finishes.
Thoroughly rinse the device with fresh water after exposure to
chlorine, salt water, sunscreen, cosmetics, alcohol, or other
harsh chemicals. Prolonged exposure to these substances can
damage the case.
Do not store the device where prolonged exposure to extreme
temperatures can occur, because it can cause permanent
damage.
Cleaning the Device
1
Wipe the device using a cloth dampened with a mild
detergent solution.
2
Wipe it dry.
Caring for the Heart Rate Monitor
NOTICE
A build up of sweat and salt on the strap can decrease the
ability of the heart rate monitor to report accurate data.
• Rinse the strap after every use.
• Hand wash the strap occasionally, using a tiny amount of
mild detergent, such as dishwashing liquid.
NOTE:
Using too much detergent may damage the strap.
• Do not put the strap in a dryer.
• When drying the strap, hang it up or lay it flat.
Troubleshooting
I don't have a computer or mobile device
You can turn on the device and use it with limited functionality,
until you complete the setup process on a computer or mobile
device. Prior to setup, you can use only the step count, auto
goal, move bar, and heart rate monitor (if packaged with your
device). Your device resets your step count once a day. The
device attempts to reset your step count while you are sleeping,
based on your inactivity level from your first day of use. Your
device does not store any history data until setup is complete.
4
