To enter a waypoint name by scanning...
·
With the cursor over a blank waypoint name field, press the WPT key.
The Waypoint Scan Page will be displayed.
·
With the cursor on the desired waypoint type, press the ENT key to
activate the “scanning mode”. The nearest waypoint of the selected
type will be displayed in the waypoint field.
·
Use the right and left arrow keys to scan through the list of waypoints,
starting with the nearest list and followed by the complete list.
·
With the desired waypoint shown, press the ENT key to select the
waypoint (use the CLR key to cancel the scanning operation at any
time).
To avoid scanning through the entire waypoint list, you may want to enter the
first few characters of the waypoint name.
To scan waypoints with specified initial characters...
·
Enter the desired number of initial characters of the waypoint name
into a waypoint field as normally done when entering a waypoint
name.
·
Press the WPT key to display the Waypoint Scan Page.
·
With the cursor on the desired waypoint type, press the ENT key to
activate the “scanning mode”. The GPS 100 will immediately display
the first waypoint in the database that begins with the character(s) you
have entered.
·
Use the right and left arrow keys to scan through the list of the
waypoints that matches the entered characters.
·
With the desired waypoint shown, press the ENT key to select the
waypoint (use the CLR key to cancel the scanning operation at any
time).
Variable rate scanning is implemented to allow you to quickly go from one end
of the list to the other. When the arrow keys are pressed briefly, you will go
through the waypoints one at a time. As you hold the arrow keys for a longer
4-7
