190-01499-02
GTX 3X5 Transponder TSO Installation Manual
Rev. 4
Page 4-13
4.9 Vertical Remote Mount Unit Installation and Removal
NOTE
When a unit is installed make sure it successfully powers up. Refer to section 6 for
configuration procedures.
NOTE
The connector backplate can be attached/detached before or after the installation/removal
of the GTX 3X5 onto the base.
Insertion
1. Insert the toe of the GTX 3X5 shoe into the base at an angle.
2. Make sure the unit is fully engaged and in line with the base.
3. Rotate the GTX 3X5 down flat onto the base.
4. Rotate the base locking mechanism up and place the cup over the shoe.
5. Rotate the knob clockwise until tight.
6. Directly attach the connector backplate to the GTX 3X5 with two screws using a 3/32” hex tool.
Removal
1. On the base, pull the knob back.
2. Rotate knob counter-clockwise.
3. Remove the cup off of the shoe.
4. Lift the end of the GTX 3X5 from the base and remove the unit.
5. Detach the connector backplate from the GTX 3X5 with a 3/32” hex tool.