Installation Procedure
190-01499-02
GTX 3X5 Transponder TSO Installation Manual
Rev. 9
Page 4-1
4
Installation Procedure
4.1
Wire Harness Installation
All electrical connections, except for the antenna(s) and shield grounds, are made through the D-sub connectors on the
rear of the unit. The shield grounds terminate to the connector backshells.
For additional information:
•
For rear connector pinout and descriptions of interface connections refer to section 5
•
For interconnect diagrams, refer to appendix D
•
For special tools, refer to section 3.15
Give sufficient space for installation of cables and connectors. The installer supplies and assembles all cables. Cable
lengths are dependent upon the installation.
To install pins into connectors and build a wire harness:
1.
Remove 0.17 inches of insulation from wires going to the connectors.
2.
Put the wire into the pin and crimp with one of the recommended (or equivalent) crimping tools.
3.
Put the pin into the connector housing location as specified by the interconnect drawings in appendix D.
4.
Gently pull on the wire to make sure the pin is properly engaged into the connector.
5.
Route and attach the cable run from the GTX 3X5 to the other units. Refer to section 3.17.
Содержание GTX 335
Страница 1: ...190 01499 02 June 2017 Revision 9 GTX 3X5 Transponder TSO Installation Manual ...
Страница 199: ......