Installation Procedure
190-01499-02
GTX 3X5 Transponder TSO Installation Manual
Rev. 9
Page 4-5
4.4
Connector and Backshell Assembly
CAUTION
DO NOT PLACE THE CONCAVE SIDE OF THE STRAIN RELIEF CLAMP (9) ACROSS THE CABLE BUNDLE.
THE CABLE BUNDLE CAN BE DAMAGED.
NOTE
The configuration module and GAE use the same connector pin locations and cannot be used at the
same time.
NOTE
Each tapped hole on the backshell (1) will only take two ring terminals (15). It is recommended to
terminate a maximum of two wires (13) per ring terminal. This necessitates the use of a ring terminal,
#8, insulated, 14-16 AWG (MS25036-153). If only a single wire is left or if only a single wire is necessary
for this connector, a ring terminal, #8, insulated, 18-22 AWG (MS25036-149) can be used. If more wires
exist for the connector than two per ring terminal, it is permitted to terminate three wires per ring
terminal.
For this procedure refer to figure 4-2 and figure 4-3.
1.
Insert flathead screws (3) through holes on the shield block (2).
2.
Attach to the backshell (1).
3.
Insert the crimped wire harness contacts (14) in the D-sub connector (10). For the chosen contact location. refer
to appendix D.
4.
Install the configuration module or GAE wires into the connector if a configuration module or GAE is used. Refer
to section 4.5.
5.
Group wires as applicable for the connector.
6.
Wrap the cable bundle with silicone fusion tape (19) so the backshell strain relief and cast housing touches the
cable bundle.
7.
Place the backshell around the connector and wire harness so it rests against the front of the backshell.
8.
Place the smooth side of the backshell strain relief clamp (7) across the cable bundle.
9.
Attach with three 4-40 x 0.375" pan head screws (6).
10. Attach configuration module. Refer to section 4.5 and figure 4-4.
11. Attach the cover (8) to the backshell using two screws (9).
12. On the pan head screw(16) place in order:
a.
Split washer (17)
b.
Flat washer (18)
c.
First ring terminal (15)
d.
If necessary, second ring terminal
13. Insert the assembled pan head screw (16) into the tapped holes on the shield block (2).
Содержание GTX 335
Страница 1: ...190 01499 02 June 2017 Revision 9 GTX 3X5 Transponder TSO Installation Manual ...
Страница 199: ......