3
2
To attach the yoke mount to the yoke shaft or control arm:
1. Open the clamp by turning the clamp adjustment knob counter-clockwise until it
can be easily placed over the yoke shaft or control arm.
2. When in place, tighten the clamp adjustment knob.
3. Use the pivot knob to position the yoke mount.
To install the GPSMAP 196/296/396 in the yoke mount:
1. Make required auxiliary power,
mini USB, and remote GPS
antenna cable connections on
the back of the unit. Clip the
GPSMAP 196/296/396 into the
cradle of the yoke mount.
2. Slide the locking lever
on the side of the cradle
forward to secure the
GPSMAP 196/296/396 in
place.
3. Adjust the cradle for best
viewing and operation of the
GPSMAP 196/296/396, and
then tighten the knob.
4. To remove the GPSMAP
196/296/396, slide back the
locking lever on the the cradle,
and then unclip the unit from
the cradle.
NOTE:
You may need to readjust the GPSMAP 196/296/396 position to provide the
best view of the display screen as lighting conditions change.
To secure the cable on the top of the yoke mount:
1. Remove the screws securing the cable clamp.
2. Orient the cable and secure with the clamp.
Yoke Mount Assembly
GPSMAP 196/296/396 Cradle
GPSMAP 196/296/396
Cradle
Adjustment
Knob
Locking Tab
To reconfigure the yoke mount for center column yokes:
1. Loosen and remove the pivot knob spacer and rubber washer.
2. Rotate the clamp assembly 90
o
so that the clamp opening faces away from you.
3. Secure the clamp assembly to the rest of the yoke mount using the pivot knob,
spacer, and rubber washer. Adjust the clamp angle before fully tightening the
pivot knob.
Yoke Mount in Forward-Facing Configuration
Yoke Mount in Conventional Configuration
Rubber Washer
Spacer
Clamp Assembly
Pivot Knob
Cable Clamp
