Garmin GPSMAP 500 Series, Руководство по установке

Страница: 86 / 107

500 SERIES INSTALLATION MANUAL Page 5-13
P/N 190-00181-02 Page Rev. B
5.2.13 STORMSCOPE CONFIG Page
(Only if 500 Series unit configured for BFG WX-500 Stormscope interface)
Select the STORMSCOPE CONFIG Page (see Figure 5-
12). This page shows the BF Goodrich WX-500
Stormscope configuration as reported by the WX-500
through RS-232 data.
Verify that the STATUS field indicates “Ok”, and that the
other displayed parameters are correct. Verify that all the
boxes in the lower portion of the page are green.
When a 500 Series unit is used with a WX-500
Stormscope, the “Synchro” or “Serial” heading formats
may be used. If another heading format is used, lightning
strike information will be visible on the Weather Page, but
not the Map Page or Arc Page.
5.2.14 STORMSCOPE TEST Page
(Only if 500 Series unit configured for BFG WX-500 Stormscope interface)
Select the STORMSCOPE TEST Page (see Figure 5-13).
This page shows current strike activity, WX-500 status, and
the heading supplied by the WX-500. The WX-500 mode
may be changed to ‘Demo’, ‘Noise monitor’, ‘Self test’,
‘Strike test’, or ‘Weather’.
Verify that the WX-500 mode can be changed. Refer to the
WX-500 manual for specific installation test procedures for
the WX-500, using this page to view strike data, change the
WX-500 mode, view WX-500 status, trigger count, and
heading.
5.2.15 STORMSCOPE DOWNLOAD DATA Page
(Only if 500 Series unit configured for BFG WX-500 Stormscope interface)
Select the STORMSCOPE TEST Page (see Figure 5-14).
This page shows raw data downloadable from the WX-500.
Optional sets of data include WX-500 software version,
environmental conditions, configuration, and fault data.
Verify that the configuration data is correct as intended.
To request which packet of data to display, highlight the
data group title and use the small right knob to select the
desired group.
Figure 5-12.
STORMSCOPE CONFIG Page
Figure 5-13.
STORMSCOPE TEST Page
Figure 5-14. STORMSCOPE
DOWNLOAD DATA Page