Garmin GNC 420AW, Руководство по установке

Страница: 23 / 236

400W Series Installation Manual Page 1-7
190-00356-02 Rev. G
1.4.5 VOR Specifications (GNS 430W Only)
Receiver Audio Sensitivity At -103.5 dBm (S+N)/N shall not be less than 6 dB.
Course Deviation Sensitivity -103.5 dBm or less for 60% of standard deflection.
Flag
The VOR Course Deviation Flag must be flagged:
a) in the absence of an RF signal.
b) in the absence of the 9960 Hz modulation.
c) in the absence of either one of the two 30 Hz
modulations.
d) When the level of a standard VOR deviation test signal
produces less than a 50% of standard deflection.
AGC Characteristics
From -99 dBm to -13 dBm input of a Standard VOR Audio
Test Signal, audio output levels shall not vary more than 3
dB.
Spurious Response
Greater than 80 dB.
VOR OBS Bearing Accuracy The bearing information as presented to the pilot does not
have an error in excess of 2.7° as specified by RTCA DO-196
and EuroCAE ED-22B.
Audio Output
A minimum 100 mW into a 500
Ω
load.
Audio Response Less than 6 dB of variation between 350 and 2500 Hz.
Except the 1020 Hz Ident Tone is at least 20 dB down in
voice mode.
Audio Distortion The distortion in the receiver audio output does not exceed
10% at all levels up to 100 mW.
1.4.6 LOC Specifications (GNS 430W Only)
Receiver Audio Sensitivity At -103.5 dBm (S+N)/N shall not be less than 6 dB.
Course Deviation Sensitivity -103.5 dBm or less for 60% of standard deflection.
Flag
The LOC Course Deviation Flag must be flagged:
a) in the absence of an RF signal.
b) When either the 90 or 150 Hz modulating signals is
removed and the other is maintained at its normal 20%.
c) In the absence of both 90 and 150 Hz modulation.
d) When the level of a standard localizer deviation test
signal produces less than a 50% of standard deflection.
AGC Characteristics From -86 dBm and -33 dBm input of a Standard VOR Audio
Test Signal, audio output levels does not vary more than 3
dB.
Selectivity Nose Bandwidth: The input signal level required to produce
the reference AGC voltage does not vary more than 6 dB
over the input signal frequency range of ± 9 kHz from the
assigned channel frequency.
Skirt Bandwidth: The input signal level required to produce
reference AGC voltage will be at least 70 dB greater than the
level required to produce reference AGC voltage at the
assigned channel frequency at ± 36 kHz from the assigned
channel frequency.
Spurious Response
Greater than 80 dB.
Centering Accuracy
Typical 0
±
3 mV (Max error 9.9 mV per RTCA DO-195).
Audio Output
A minimum 100 mW into a 500
Ω
load.
Audio Response
Less than 6 dB of Variation between 350 and 2500 Hz.
Except the 1020 Hz Ident Tone is at least 20 dB down in
voice mode.
Audio Distortion
The distortion in the receiver audio output does not exceed
10% at all levels up to 100 mW.