Garmin GDR 66, Инструкция по установке

Страница: 17 / 40

GDR 66 Installation Manual Page 2-1
190-00303-24 Revision A
2 INSTALLATION OVERVIEW
2.1 Introduction
This section provides hardware equipment information for installing the GDR 66, related hardware, and
antennas. Installation of the GDR 66 must follow the aircraft TC or STC requirements. Cabling is
fabricated by the installing agency to fit each particular aircraft. The guidance of FAA advisory circulars
AC 43.13-1B and AC 43.13-2B, where applicable, may be found useful for making retro-fit installations
that comply with FAA regulations.
Refer to Appendix A for rack drawings and dimensions.
2.2 Installation Materials
The GDR 66 is only available as a single unit under the following part number:
2.2.1 Equipment Available
Each of the following accessories are provided separately from the GDR 66 and are required for
installation.
2.2.2 Additional Equipment Required
The following installation accessories are required but not provided:
* Only required for voice mode
** Used for mounting unit rack to airframe
Table 2-1 Available Units
Item Garmin P/N
GDR 66 Unit Only, (011-02303-00) 010-00832-00
Table 2-2 Equipment Available
Item Garmin P/N
GDR 66 Standalone Install Rack 011-02477-00
GDR 66 Connector Kit 011-02304-00
Table 2-3 Additional Equipment Required
Characteristic Specification
COM Antenna
Shall meet TSO-C37(), C38(), and C-169(). Broad band, 50
Ω
, vertically polarized
with coaxial cable
Headphones* 500
Ω
nominal impedance
Microphone* Low impedance, carbon or dynamic, with transistorized pre-amp
Hardware** #10 pan head or hex head fastener (qty 4)
DRAFT