3 Cut the mounting surface along the inside of the dashed line on the template.
4 Ensure the mounting holes on the stereo line up with the pilot holes on the template.
5 Using an appropriately sized drill bit for the mounting surface and screw type, drill the pilot holes.
6 Remove the template from the mounting surface.
7 Complete an action:
• If you are installing the stereo in a dry location, place the included mounting gasket on the back of the
stereo.
• If you are installing the stereo in a location that is exposed to water, apply silicone-based marine sealant
on the mounting surface around the cutout.
NOTICE
Do not install the included mounting gasket if you applied sealant to the mounting surface. Using sealant
and the mounting gasket may reduce water resistance.
8 If you will not have access to the back of the stereo after installation, make the necessary wiring
connections.
9 Secure the stereo to the mounting surface using the included screws .
You should hand-tighten the screws when securing the stereo to the mounting surface to avoid over
tightening them.
10 Snap the screw covers in place .
Connection Considerations
You must connect the stereo to power, to speakers, and to media input sources. You should carefully plan
the layout of the stereo, speakers, input sources, and optional Fusion PartyBus
™
devices and Fusion PartyBus
network before making any connections.
3
