Garmin Fusion Apollo MS-ERX400, Руководство пользователя, Страница: 13 / 20

Update Options
Select , select the name of the device, and select SETTINGS > UPDATE .
ERX REMOTE : Updates the remote control from a stereo connected to the ETHERNET port or the Fusion
PartyBus network using a valid software update file on a USB flash drive connected to the stereo ( Software
Updates , page 10 ).
FACTORY RESET : Restores all settings to the factory default values.
Network Settings
Select > SETTINGS , select the name of the remote control, then select NETWORK.
DHCP CLIENT : Sets the device as a DHCP client. This is the default setting for all devices that are not
configured to be a DHCP server.
STATIC IP : Allows you to set a static IP address for the device ( Setting a Static IP Address , page 9 ).
GARMIN MARINE NETWORK : Allows the device to be used on a Garmin ® Marine Network so it can be viewed
and controlled by connected Garmin chartplotters.
RESET : Resets the network configuration on the remote control to factory defaults.
DETAILS : Shows information about the network configuration.
SAVE : Allows you to save changes to the network settings.
Setting the Device as a DHCP Client
This device is set as a DHCP client by default. When set as a DHCP client, the device is configured for use on a
network with a DHCP server. If no DHCP server is present on the network, the device assigns its own local IP
address after a short delay.
NOTE: Although the Fusion PartyBus devices can communicate with each other without a DHCP server on the
network, the devices take longer to connect to each other when you first turn them on. It is highly recommended
to have one properly-configured DHCP server on the network for the best results.
1 Select > SETTINGS .
2 Select the name of this device.
3 Select NETWORK > DHCP CLIENT > SAVE .
Setting a Static IP Address
If the stereo is configured as a static IP, it is automatically assigned the IP address of 192.168.0.1. You can
change this IP address.
If the stereo is a DHCP client on the network and you do not want the DHCP server to automatically assign an
IP address to the stereo, you can set a static IP address.
NOTE: Every device on the network must have a unique IP address. If you select a static IP address that is the
same as the IP address on the network, the devices will not work properly.
1 Select > SETTINGS .
2 Select the name of the remote control.
3 Select NETWORK > STATIC IP .
4 Select an option:
• To set the IP address, select
IP , and enter the IP address.
• To set the subnet mask, select MASK , and enter the subnet mask.
NOTE: The subnet mask must match all other devices on the network to work properly. A typical subnet
mask is 255.255.255.0.
• To set the default gateway IP address, select GATEWAY , and enter the gateway IP address.
NOTE: The default gateway is typically set as the IP address of the DHCP server on the network.
5 Select SAVE .
General Settings 9