Garmin Fusion Apollo MS-ERX400, Руководство пользователя

Страница: 12 / 20

Group Synchronization
By default, groups you create are not maintained when you turn off stereos in the group. If you turn off a single
stereo added to the group, it leaves the group. If you turn off the primary stereo in the group, the group is
dissolved. You can enable group synchronization to preserve group membership for a stereo after turning it off.
Group synchronization behaves differently based on how you turn the stereos off and on.
• If you turn a synchronized stereo off and on by using either the power button on the stereo or a physical
switch on the ignition wire (the red wire), all of the synchronized stereos in the group turn off and on together.
This applies to all of the synchronized stereos in the group, whether or not a stereo is the primary stereo in
the group.
NOTE: Selecting ALL OFF from the power menu on a stereo turns off all stereos on the network, even if they
are not in a group or have group synchronization enabled.
• If you turn a synchronized stereo off and on using a physical switch on the power wire (the yellow wire), the
other synchronized stereos in the group behave differently:
◦ If the synchronized stereo is the primary stereo in the group and you turn it off using a physical switch on
the power wire, the other synchronized stereos in the group remain on, but leave the group. When you turn
the primary stereo back on again, the other synchronized stereos rejoin the group.
◦ If the synchronized stereo is not the primary stereo in the group and you turn it off and on using a physical
switch on the power wire, all of the other synchronized stereos in the group remain on and grouped, and
the stereo rejoins the group when you turn it on again.
Enabling Group Synchronization
You must remove the stereo from an existing group before you can enable the GROUP SYNC setting. You
cannot update settings when a stereo is part of a group.
You must enable this setting on each stereo that you want to retain group settings after a power cycle.
1 Select > SETTINGS .
2 Select the name of the stereo.
3 Select POWER OPTIONS > GROUP SYNC .
The stereo retains group settings after a power cycle.
4 Repeat for additional stereos as needed.
NOTE: You must enable GROUP SYNC on all networked stereos for synchronization to work properly.
General Settings
Select , select the name of the remote control, and select SETTINGS.
NOTE: If you select the name of the currently-controlled stereo before you select SETTINGS, you can adjust
the settings of the stereo instead of the remote control.
When a stereo is in a group, you cannot change settings on that stereo.
The following setting descriptions apply to the remote control only. For information about stereo-specific
settings, see the stereo owner's manual.
DEVICE NAME : Assigns a name to the remote control for better identification on the network.
LANGUAGE : Sets the language used on the remote control.
POWER OPTIONS > POWER SAVE : Disables the LCD backlight after one minute of inactivity to save battery
power.
ASSIGN HOME ZONE : Assign the default zone on a connected stereo for the remote control.
NETWORK : Adjusts network settings ( Network Settings , page 9 ).
UPDATE : Update or reset the remote control ( Update Options , page 9 ).
ABOUT : Shows the software version for the remote control.
8 General Settings