Garmin COMPACT REACTOR 40, Руководство по установке

Страница: 17 / 24

Building a Basic NMEA 2000 Network for the Autopilot System
NOTICE
If you are installing a NMEA 2000 power cable, you must connect it to the boat ignition switch or through
another in-line switch. NMEA 2000 devices will drain your battery if the NMEA 2000 power cable is connected to
the battery directly.
A dedicated helm control is not included in all autopilot packages. If you install the autopilot without a dedicated
helm control, the autopilot CCU must be connected to the same NMEA 2000 network as a compatible Garmin
chartplotter to configure and control the autopilot system.
1 Connect the three T-connectors together side-by-side.
2 Connect the included NMEA 2000 power cable to a 9 to 12 Vdc power source through a switch .
You should connect the power cable to the ignition switch of the boat if possible, or route it through an inline
switch (not included).
NOTE: The braided drain wire (bare) on the NMEA 2000 power cable must be connected to the same ground
as the black wire on the NMEA 2000 power cable.
3 Connect the NMEA 2000 power cable to one of the T-connectors.
4 Connect one of the included NMEA 2000 drop cables
to one of the T-connectors and to the helm control
(optional) or to a compatible Garmin chartplotter .
5 Connect the other included NMEA 2000 drop cable to the other T-connector and to the CCU .
6 Connect the male and female terminators to each end of the combined T-connectors.
17