Garland XG24-JIB, Инструкция по установке и эксплуатации

Страница: 20 / 40

Part # 4523133 Rev 4 (08/04/09) Page 20
18. Rinse the lower grill by flooding the surface twice with
lukewarm water. Squeegee after each rinse.
19. Wipe the lower grill surface, backsplash, bullnose, and
hood with a clean, damp cloth.
CLEANING AND MAINTENANCE
continued
20. When cleaning is completed, you may turn the “MASTER
POWER” (rocker) switch off.
AFTER CLEANING, apply a thin coat of fresh shortening
to the lower grill surface only. Wipe down the
surrounding areas. Empty, wash, rinse, and replace the
grease troughs.
PLATEN ZEROING
Turn Master power switch “ON”, wait for controllers to display
“OFF”.
Note: Release sheets should not be installed during this
procedure.
1. Press and hold for three, (3) seconds. “ENTER CODE” is
displayed.
2. Using the Product buttons, 0-9 enter the code, (1251).
“ENTER CODE **** ” is displayed.
3. Press to enter the Programming Mode.
“PROGRAMMING MODE MENU ITEMS” is displayed.
4. Press two, (2) times in succession to display
“PROGRAMMING MODE SYSTEM SETUP.”
5. Press six, (6) times. “PLATEN SET +/- XX” is displayed.
(XX=numbers that will vary from grill to grill.)
6. Allow time for grill to heat and turn ready. Press
both the Cancel (Green) and Standby (Black) buttons
simultaneously to lower the upper platen. Press the
Cancel (Green) button to raise the platen. Now, press
both the Cancel (Green) and (Black) Buttons to re-lower
the platen.
7. Remove platen adjuster caps from all four adjustment
points on each platen. Remove the four locking caps from
the adjustment points.
8. Using the adjusting tool lower platen until adjusting tool
touches the arm assembly.
9. With gapping tool, adjust right rear of platen until the
gapping tool fits snugly between the upper platen and
grill surface.
10. Move next to the left front adjuster and raise the platen
until the gapping tool fits snugly between the upper
platen and grill surface.
11. Next go to the left rear adjuster and raise the platen until
the gapping tool fits snugly between the upper platen
and grill surface.
12. Move next to the right front adjustment and raise the
platen until the gapping tool fits snugly between the
upper platen and grill surface.
13. Repeat steps 9-12 one or more times until gapping tool
fits snugly between the upper platen and grill surface at
all four adjustment points without further adjustment.
(See diagram below.)
14. Replace the platen adjuster locking caps “hollow side
down” and tighten snugly. Replace platen adjuster caps.
15. Repeat steps 9-14 for each platen.