Part Number 4533030 Rev 1 07/2017 9
Section 2
Installation
INSTALLATION SAFETY—DISCLAIMER
DANGER
Installation must be carried out by registered installation
contractors only.
The contractors are responsible for interpreting all
instructions correctly and performing the installation
in compliance with all applicable national and local
regulations.
The warning signs and serial plates on the equipment
must strictly be followed.
n
Warning
This equipment is intended for indoor use only. Do not
install or operate this equipment in outdoor areas.
INSTALLATION SAFETY—CLEARANCE AND
VENTILATION
DANGER
Risk of Fire or Shock or Equipment Failure
All minimum clearances must be maintained. Air intake
vents and exhaust vents must not be blocked or be
restricted by the installation.
,
Caution
This equipment must only be operated under an
approved ventilation system in accordance with all
applicable national and local regulations. Exceptions
may apply.
,
Caution
Where this appliance is to be positioned in close
proximity to a wall, partitions, kitchen furniture,
decorative finishes, etc., it is recommended that they
be made of non-combustible material, if not, they shall
be clad with suitable non-combustible heat-insulating
material, and that the closest attention be paid to fire
prevention regulations.
(P/N 2624300)
,
Caution
Do not position the air intake vent near steam or heat
exhaust of another appliance.
INSTALLATION SAFETY—ELECTRICAL
DANGER
All electrical connections must be carried out by a
certified electrical contractor, who is responsible for
the correct rating and installation of the appliance. The
contractor has to comply with all legal safety regulations
and all applicable national and local electrical codes.
n
Warning
Markings and warning labels mounted directly on the
equipment must be observed at all times and kept in a
fully legible condition.
n
Warning
This equipment must be grounded.
Notice
Ensure the supply voltage and the line current match
the specifications given on the serial plate affixed to the
appliance. Wrong voltage will damage the appliance. A
stable power supply must be provided.
Notice
Always refer to the serial plate on the appliance to verify
the electrical data. When the data listed on the serial
plate is different than that listed in this manual, contact
the manufacturer or the authorized representative.
