Garland ROLL&COMB KEEPER 40V 600, Инструкция по эксплуатации

Страница: 31 / 104

English English
31/104
6.1. UNPACKING AND LIST OF MATERIALS
This machine includes the following items that you will
find inside the box:
1. Machine x1
2. Lower handlebar x1
3. Upper handlebar x1
4. Collecting bag x1
5. Wing nuts x4
6. Long Screws x4
7. Washers x4
8. Short Screws x2
9. Nuts x2
10. Clip x2
Carefully remove all items from the box and make
sure that all listed items are present. Carefully inspect
the product to ensure that there are no damaged
elements.
If you find any damaged or missing parts, do not use
the machine until the defect has been repaired or
all the missing pieces replaced. Using the machine
without all of its parts or with defective parts can
cause severe personal injury.
6.2. MOUNTING THE HANDLEBAR
The handlebar of this machine is disassembled at the
factory. To mount the lower handlebar:
• Place the machine (1) on a flat surface.
• Place the lower handlebar (2) on the machine (1).
Use two long screws (6), two short screws (8), two
washers (7), two nuts (9) and two wing nuts (5) for
this action. Choose the position H (high) or L (low)
that best suits and insert one of the long screws
(6).
• On the other side, insert a washer (7) and screw in
the wing nut (5)
• Insert one of the short screws (8) into the upper
cavity.
• On the other side, screw the nut (9). Repeat the
operation on the other side of the handlebar.
6. START UP INSTRUCTIONS