INSTALLATION/OPERATION MANUAL
GARLAND ELECTRIC CLAMSHELL GRILL WITH PRODUCT RECOGNITION MODEL MWE3W
PART #4521777 (03/19/08)
Page 10
INSTALLATION
(continued)
1. Uncrate unit from crating material
IMPORTANT: RATING PLATE FOR THIS EQUIPMENT IS
LOCATED IN TWO PLACES. ONE IS LOCATED INSIDE BACK
PANEL ON LEFT SIDE, SECOND RATING PLATE LOCATED
UNDER FRONT CONTROL PANEL IN CENTER.
CAUTION: Prior to installation, check the electrical supply
to ensure input voltage and phase match the equipment
voltage rating and phase. See data plate located rear left
side of grill. Back panel removal is required.
NOTE: ENSURE THAT PLATENS ARE STRAPPED DOWN TO
PREVENT PLATENS FROM RAISING. SEVERE DAMAGE MAY
OCCUR.
2. Tip unit over on its back, and install casters. Lock jam
nuts in place.
3. Carefully rotate grill back on its casters.
4. Remove back body side and Install power cords per
your country / areas specifications.
2 x 50AMP NEMA 15-50
MWE3 Standard Electrical Cord Hookup
Ora Red Blk
Lim
120 120 Com Wht
Wht Wht
E
Lim
Ora Red Blk
Lim
120 120 Com Wht
Wht Wht
E
Lim
1 x 20AMP NEMA 21-20
WARNING: Electrical appliances must be electrically
grounded in accordance with local codes or in the absence
of local codes, with national electric code ANSI/NFPA
- latest version.
5. Install grease bucket rails as shown below:
