Garland MULE 661 E, Инструкция по эксплуатации

Страница: 29 / 112

English
28/112
English
29/112
6.3.1. FIXING CABLE EXTENSION
Only use cable extensions that
are homologated for outdoor
use. The cable section must
be at least 1.5 mm
2
and the
cable extension should never
be longer than 25 m and must
be completely unrolled before
starting to work.
Fix the extension of the tiller by inserting cable in the
hook on the handle and plug onto the machine.
6.4. START UP AND STOPPAGE
Start up of the machine:
Turn the security lever
to the position and
without letting go, press the
On/Off switch.
Stoppage of the machine:
Let go of the On/Off switch
.
5.5. TRANSPORT WHEELS AND SPUR
Attention: To work with the tiller´s transport
wheels, these must be in the working position, the
spur coming into work.
To place the wheels in the working position, pull the
ring that unblocks the wheels and lift these until they
are fixed by the button.
To place the wheels in the transport position, release
the wheels by pressing the button and bring down
fixing them with the ring provided.
6.6. OVERLOAD PROTECTION
This tiller has a security switch that will disconnect
the machine under the following conditions:
• If too much material accumulates on the blades.
• If the material being worked on is too resistant for
the engine capacity.
• If the machine detects a high level of resistance on
the blades.
If you detect that the machine does not start when
the switch is on the On position, the probable cause
will be that the security switch is activated. In this
case disconnect the machine from the mains, check
that the blades are clean and have no elements that
impede the blades from turning and wait 15 minutes
before starting the machine again.
Transport position:
Supporting ring of the
transport wheels
Working position:
Spur
Fixing button for the
transport wheels.