Garland INDIANA 14, Инструкция по эксплуатации

Страница: 53 / 172

English English
53/172
8.2. OTHERS
Carry out periodical inspections with the aim
of ensuring a safe and efficient performance
from the tool. For a complete inspection of
the tool, please contact your distributor.
Keep the machine clean, especially the areas near the
gas tank and air filter.
Before adjusting or repairing the machine, make sure
the engine is stopped and the cover of the spark plug
has been removed.
Use the appropriate parts in order to obtain a safe and
adequate performance from the product. These parts
can be obtained from your distributor.
The use of other accessories could can
cause potential risks, injuries to the operator
or damage to the machine.
8.2.1. AIR FILTER
The obstruction of the air filter will cause the
performance of the engine to decrease. If necessary,
inspect and clean this element. If any damage or
alteration is observed, replace it with a new one.
To clean the dirt on the filter open the cover unscrew
the lid and remove the filter.
The dust on the surface
of the filter can be
removed by hitting
a corner of the filter
against a hard surface.
To clean the dirt inside of INDIANA 12 and 10,
separate both parts of the filter by using a screwdriver,
as shown in the drawing, and brush them with petrol.
If compressed air is used always blow from the inside,
to ensure better cleaning.
To assemble the two halves
of the cleaner, place one part
against the other and press
the edges until they click.
The INDIANA 14 has a paper
filter that cannot be cleaned. This
should be replaced when dirty.
8.2.2. ADJUSTMENT OF THE
CARBURETOR
Carburetor regulation is complicated and we
recommend it is done by a person with
experience or by the customer service.
Do not adjust the carburetor unless it is necessary. If
any problems with the carburetor are observed, see
your distributor.
The incorrect adjustment of the element could
damage the engine, as well as causing the warranty
to be cancelled.
8.2.3. FUEL FILTER
The fuel tank is provided
with a filter (1). This
element is located at the
extreme end of the fuel
hose and it can be removed
fuel opening with the help
of a piece of wire bent into
a hook or similar device.
Inspect the fuel filter periodically. Do not allow dust
to enter the fuel tank. The obstruction of the filter will
make it difficult to start the engine or it will produce
abnormalities in the performance of the engine.