Garland G24 SERIES, Инструкция по установке и обслуживанию

Страница: 11 / 16

Part # 4521357 (12/07) Page 11
OPERATION INSTRUCTIONS
Operating Controls
OFF
IGNITION
FULL FLAME
LOW FLAME
Lighting The Griddle
NOTE : Ensure the gas supply to the appliance is turned “ON” .
During the initial ignition cycle, air must be purged from the
gas line and thus it may take one or two minutes for the pilot
burner to ignite .
1 . Push in the tap and turn it counter-clockwise to the
ignition position “ ” .
2 . Holding the tap fully in, light the pilot with a match or
taper .
3 . When the pilot is lit, continue to hold the tap fully in for 20
seconds, then release it If the pilot goes out, wait for five
(5) minutes then repeat from step 1 .
4 . When the pilot is established, push the tap in and turn it
counter-clockwise to the full flame “ ” position .
5 . For low flame or simmer, push the tap in and turn it
counter-clockwise to the low flame “ ” position .
6 . To shut the burner off, turn the dial to the “ ” symbol and
the safety device will disengage within 60 seconds .
Safety
It is the responsibility of the supervisor or equivalent
person to ensure that users of this equipment wear suitable
protective clothing and to draw attention to the fact that
some parts will by necessity become very hot and will cause
burns if touched accidentally .