Garland G18-BRL, Инструкция по установке и эксплуатации

Страница: 9 / 16

Part # 4525958 (10/28/08) Page 9
Mounting Holes
for Broilers to
Stand When
Optional Cross
Members
are Required
Mounting Holes
For Broiler
to Stand
Optional Cross Members
and Cross Member Mounting
Brackets, Reqd . only when Units
exceed a 4 ft . Dim . if Reqd . Secure
the pieces together with
10 ea . 10-24 Machine Screws
10 ea . 1/4" Lock Washers
10 ea . 10-24 Hex Nuts
INSTALLATION continued
Leg Installation
1 . All units are shipped with N .S .F . approved legs . These legs
must be installed to provide a minimum clearance of
four (4) inches between the counter top and bottom of
the unit in order to meet National Sanitation Foundation
requirements .
2 . When using the legs described above, raise front of unit
and screw leg into leg retaining nut provided at each
corner of unit, repeat at rear .
3 . Unit may be leveled by adjusting legs . Use a spirit level
and level unit (by cooking grids) four (4) ways: across the
front and back and down the sides .
Assembly of Counter Stands
1 . Fit stand ends together, see diagram .
2 . Secure stand together with eight (8) 10-24 machine
screws, eight (8) 1/4” lock nuts, eight (8) 10-24 hex nuts
provided . Use only front and back pieces .
3 . If stand exceeds a four (4) foot length see optional cross
member . Optional cross member mounting brackets
secure with 10 (10) each of the following provided: 10-24
machine screws, 1/4” lock washers, 10-24 hex nuts .
4 . Stand is complete
5 . Position square foot insert in bottom leg openings .
6 . Tap insert up into leg until it seats at collar flange .
7 . Repeat above steps, for each leg that requires the square
foot insert .
Installation of Casters
1 . Position caster pad on leg, as shown in drawing
2 . Drill four (4) 5/32” diameter holes in leg to secure caster
pad .
3 . Secure caster pad to leg . Use four (4) #10 AB small screws
provided per leg .
4 . Screw caster into caster pad, secure tightly .
5 . Repeat above steps for each leg .