![background image](http://html1.mh-extra.com/html/garland/chopper-555-ve/chopper-555-ve_instruction-manual_3601335041.webp)
English
English
41/120
switch on the engine by pressing the switch and
pushing both the hydraulic control levers at the same
time, the blade will begin its cutting motion. While the
blade is moving stop pressing the left lever and blade
should stop and move back to its original position.
Then perform the same test operation.
If after the test you detect that the machine does
not function as described in this point do not reuse
the machine until it has been reviewed by a service
technician.
5.3.4.2. LEAK VERIFICATION
Check that there are no oil leaks in the machine. If you
detect a leak, take your machine in for service.
5.4. AFTER USE
Once you have stopped using the machine:
1. Disconnect the power source of the machine by
pressing the switch in position “O”.
2. Unplug the machine.
3. When you stop using the machine tighten the
bleed screw to prevent oil leakage from the
bandsaw through the trap.
6. USING THE MACHINE
Use this machine only for the designated
purposes. Using this chainsaw for any other use is
dangerous and can cause bodily harm and/or damage
to the machine.
Never force the bandsaw for more than 5 seconds
by pressing on a trunk too hard. After this interval,
oil that is under pressure can overheat and damage
the machine. For logs of extreme hardness, turn the
log 90 degrees to try to cut it in another position. If
still cannot cut the trunk, it means that this exceeds
permissible hardness so trunk should be discarded
and thus prevent damage to the machine.
Note: Is strictly forbidden to use the bandsaw by two
people with a clamping trunk and the other pressing
the levers. Locking a lever (to only having to operate
with lever) is also prohibited.
6.1. LOG CUTTING
1. Follow the steps in point 5.3. “Start-up”.
2. Place the trunk on the work table and grasp it
firmly between the clamps. Make sure the trunk
does not become kinked, move or slip while they
are being cut.
3. Simultaneously press both the hydraulic control
levers down.
4. Break the trunk.
5. Stop pressing the levers so that the blade is
removed.
6. Once work is complete, follow the steps in point 5.4.
7. MAINTENANCE AND SERVICE
Do not attempt to perform adjustments on the
machine if it is running. Perform all maintenance of
the machine with it placed on a flat, cleared, and
steady surface.
DO NOT ADJUST THE MAXIMUM
PRESSURE LIMIT SCREW! The maximum
pressure has been set at the factory.
Always perform maintenance
or service with the power cord
unplugged from the machine.
WARNING! Do not modify the machine or cutting
elements (blade). Improper use of these elements can
cause SERIOUS PERSONAL DAMAGE OR DEATH.
Содержание CHOPPER 555 VE
Страница 120: ...120 120 ελληνικά NOTES ...
Страница 121: ...121 120 ελληνικά NOTES ...
Страница 122: ...English 122 120 ελληνικά NOTES ...
Страница 124: ......