![background image](http://html1.mh-extra.com/html/garland/bolt-925-qgw/bolt-925-qgw_instruction-manual_3627436037.webp)
English
English
37/120
user, for the machine and for persons, animals and
things in its surroundings.
Verify:
• The machine completely and look for parts (bolts,
nuts, etc.) that are loose or damaged.
• That there are no fuel leaks.
• The oil level.
• That the air filter is clean. Clean the filter if
necessary.
Tighten, repair or replace everything you need to
before using the machine. Do not use any accessory
on this machine outside of those recommended by us
since its use could cause serious damage to the user,
the machine and people, animals and things close to
the machine.
NOTE: This machine has an oil sensor to prevent
the engine from starting with an oil level below the
recommended minimum. If the oil level is too low the
engine will not start.
6.5.2. PLACEMENT OF THE MACHINE
Make sure that you install the machine in a stable
position.
Connect a cable from the ground
outlet of
generator grounding.
6.5.3. START-UP
Follow the start-up procedure in cold or hot depending
on the condition of your engine.
6.5.3.1. STARTING THE MOTOR IN COLD
• Place the machine on a flat, stable surface to start it.
• Place the circuit breaker in alternating current (AC)
in the OFF position.
• Place the faucet of the fuel in the open position
(ON)
• Place the choke in closed air position (CHOKE).
• Set the switch of the motor to the on position (ON).
• Hold the machine by casting so it doesn’t move
from its position on the floor when pulling the
starter rope.
• Pull the starter rope until the engine starts.
• If the machine starts and doesn’t stop gradually
changing the air level position (air open RUN).
• Let the engine warm up for a few minutes before
using the machine.
6.5.3.2. STARTING THE MOTOR HOT
• Place the machine on a flat, stable surface to start.
• Place the circuit breaker in alternating current (AC)
in the OFF position.
• Place the fuel tap in the open position (ON).
• Place the choke in the normal working position
(open position RUN).
• Set the switch of the motor in position (ON).
• Hold the machine by the handle so it doesn’t move
from its position on the floor when pulling the
starter rope.
• Pull the starter rope until the engine starts.
• If after a few attempts the machine does not start
follow the steps in the engine starting.
Содержание BOLT 925 QGW
Страница 25: ...Español 25 120 NOTAS ...
Страница 71: ...Français 71 120 NOTES ...
Страница 95: ...Italiano 95 120 NOTE ...
Страница 120: ......