![background image](http://html1.mh-extra.com/html/garland/bolt-725-q/bolt-725-q_instruction-manual_564491038.webp)
English
38/120
English
39/120
7. USING THE MACHINE
Use this machine only for the purposes for which
it is designed. The use of this machine for any other
use is dangerous and can cause harm to the user
and/or the machine.
Do not start the machine in a room or
enclosure. The exhaust gases, fumes from
the fuel and oil contain carbon monoxide
and chemically dangerous substances.
In case of a concentration of gases produced by poor
ventilation, remove everything that impedes the flow
of clean air from the work area to improve ventilation
and do not return to work in the area unless you have
properly ventilated it and are sure that ventilation is
sufficient so that this concentration does not happen
again.
Do not use this machine when you are tired or under
the influence of drugs, alcohol or medication. A
moment of distraction while you are operating the
machine could cause serious personal injury.
Always readjust the machine in a flat stable surface.
Do not expose the machine to rain or humid
conditions. Water that enters the machine
increases the risk of electric shock.
Don’t only use the security features of this machine.
It is necessary to pay attention to the possible
loosening or overheating of the parts of the machine.
If you detect any abnormality immediately stop the
machine and check it carefully. In case of failure take
the machine to the technical service for repair. Under
no circumstance should you continue working if you
notice that the machine is not working correctly.
Remember to always use the machine with clean
hands and without remains of fuel or oil.
Be careful not to touch the hot parts of the
machine while the engine is running or
after use, as for example the exhaust, spark
plug or high voltage cables. Do not connect two or
more generators in a series or parallel.
Do not connect the 12V wires to opposite poles.
Remember that the red clamp attaches to the positive
pole (+) and the black clamp on the negative pole (-)
do not use accessories on this machine except those
recommended by our company since its use could
cause severe damage to the user, people close to the
machine and the machine.
Always follow all the security rules indicated in this
manual.
7.1. USING THE MACHINE
- Start the machine following the instruction in the
manual.
- For 3 minutes keep circuit breakers in the OFF
position to warm up the engine without load.
- If you are using alternating current (AC) select
the circuit breaker in alternating current (AC). (The
generator cannot supply both alternating current
(AC and DC current (DC)).
- Connect the appliance to the generator.
- If the connected device has higher consumption
that the generator can produce, the circuit breaker
will cut off electricity supply to protect the
generator.
- If this occurs unplug the electricity for at least one
minute, reconnect the circuit breaker.
7.2. VERIFICATION POINTS AFTER COMMISSIONING
Check that the noise of the machine is normal and
that it does not vibrate. If you detect any anomaly
Содержание BOLT 725 Q
Страница 25: ...Español 25 120 NOTAS ...
Страница 71: ...Français 71 120 NOTES ...
Страница 95: ...Italiano 95 120 NOTE ...
Страница 120: ......