![background image](http://html1.mh-extra.com/html/garland/bolt-115-g/bolt-115-g_instruction-manual_3631468033.webp)
English
English
33/106
• Place the choke in closed air position (CHOKE).
• Set the switch of the motor to the on position (ON).
• Hold the machine by casting so it doesn’t move
from its position on the floor when pulling the
starter rope.
• Pull the starter rope until the engine starts.
• If the machine starts and doesn’t stop gradually
changing the air level position (air open RUN).
• Let the engine warm up for a few minutes before
using the machine.
6.5.3.2. STARTING THE MOTOR HOT
• Place the machine on a flat, stable surface to start.
• Place the fuel tap in the open position (ON).
• Place the choke in the normal working position
(open position RUN).
• Set the switch of the motor in position (ON).
• Hold the machine by the handle so it doesn’t move
from its position on the floor when pulling the
starter rope.
• Pull the starter rope until the engine starts.
• If after a few attempts the machine does not start
follow the steps in the engine starting.
6.5.4. STOPPING THE MOTOR
• Stop the engine by moving the engine switch to the
OFF position.
• Place the tap of the fuel in the closed position
(OFF).
7. USING THE MACHINE
Use this machine only for the purposes for which
it is designed. The use of this machine for any other
use is dangerous and can cause harm to the user
and/or the machine.
Do not start the machine in a room or
enclosure. The exhaust gases, fumes from
the fuel and oil contain carbon monoxide
and chemically dangerous substances.
In case of a concentration of gases produced by poor
ventilation, remove everything that impedes the flow
of clean air from the work area to improve ventilation
and do not return to work in the area unless you have
properly ventilated it and are sure that ventilation is
sufficient so that this concentration does not happen
again.
Do not use this machine when you are tired or under
the influence of drugs, alcohol or medication. A
moment of distraction while you are operating the
machine could cause serious personal injury.
Always readjust the machine in a flat stable surface.
Do not expose the machine to rain or humid
conditions. Water that enters the machine increases
the risk of electric shock.
Don’t only use the security features of this machine.
It is necessary to pay attention to the possible
loosening or overheating of the parts of the machine.
If you detect any abnormality immediately stop the
machine and check it carefully. In case of failure take
the machine to the technical service for repair. Under
no circumstance should you continue working if you
notice that the machine is not working correctly.
Remember to always use the machine with clean
hands and without remains of fuel or oil.
Be careful not to touch the hot parts of
the machine while the engine is running
or after use, as for example the exhaust,
spark plug or high voltage cables. Do not connect two
or more generators in a series or parallel.
Содержание BOLT 115 G
Страница 83: ...Italiano 83 106 NOTE...
Страница 105: ...Portugu s 105 106 NOTE...
Страница 106: ...Portugu s 106 106 NOTE...
Страница 108: ......