Gared Pro-S 9616, Инструкция по установке, эксплуатации и обслуживанию

Страница: 13 / 18

Gared Pro-S Portable Backstop
11
22. Once the unit is relocated and the plumb bobs are exactly on the marks located in step 13,
recheck all dimensions to make sure the 10’-0” playing height is correct and the face of
the backboard is 4’-0” in front of the court baseline.
23. Insert the locator pins (item 16) into the sleeves located in the bottom rail of the unit near
the front caster wheels. Find the center of these pins on the floor and mark this
measurement on the floor.
24. Locate the center of the rear anchor on the floor and mark this measurement on the floor.
25. Remove the safety pin from the locking bar and lower the unit to the full down position.
26. Raise the leveling pads and make sure the unit is completely on the castor wheels. Push
the unit away from the playing location on the floor.
27. Refer to the installation instructions for the rear floor anchor found in the package of the
floor insert (item 33) and install the insert into the floor. This insert is to be installed at
the rear anchor location marked on the floor in step 24.
28. Using a 1” spade bit and drill, drill a 1/8” deep counter-bore at the locations marked on
the floor in step 23. Using a ¾” drill bit and drill, drill through the rest of the floor at the
center of each of the counter-bores.
29. Insert the brass floor inserts (item 19) into the holes drilled in step 28.
30. Move the unit back into the playing position. Insert the locator pins into the floor inserts.
Lower the leveling pads to the locking collar.
31. Install the rear anchor tie down bolt (item 17) on the rear of the unit and secure the
anchor bolt to the floor anchor insert.
32. Attach the backboard padding to the backboard.
33. Attach the horizontal boom pad (item 9)
to the boom just behind the backboard.
Position with the wide end of the
tapered pad around the board mounting
brackets. Refer to figure 12.
Figure 12
34. Raise the unit to the playing position and insert the safety
pin into the sliding locking bar.