Gardner Denver SAVG2-100, Инструкция по установке, эксплуатации и обслуживанию

Страница: 63 / 84

13-21-615 v01 Page 62
Excessive oil carry-over can damage equipment. Never fill oil reservoir above
the "HIGH" marker.
FILLING OIL RESERVOIR
1. Be sure the unit is completely off and that no air pressure is in the oil reservoir.
2. Disconnect, lockout and tagout the power supply to the starter.
3. Wipe away all dirt around the oil filler plug.
4. Remove the oil filler plug and add oil as required to return the oil level to the top of the fill range on the
gauge.
5. Install the oil filler plug and operate the unit for about a minute allowing oil to fill all areas of the system.
Check for leaks.
6. Shut down unit, allowing the oil to settle, and be certain all pressure is relieved.
7. Add oil, if necessary, to bring level to the top of the fill range on the gauge.
On unloaded operation and after shutdown some oil will drain back into the oil reservoir and the oil level
gauge will read
“HIGH.”
DO NOT DRAIN OIL TO CORRECT . On the next start, oil will again fill the system
and the gauge will indicate operating at the proper level. DO NOT OVERFILL as oil carryover will result.
The quantity of
oil required to raise the oil level from “LOW” to “HIGH” is shown in Figure 5-8. Repeated
addition of oil between changes may indicate excessive oil carryover and should be investigated.
Use only CLEAN containers and funnels so no dirt enters the reservoir. Provide for clean storage of oils.
Changing the oil will be of little benefit if done in a careless manner.
Refill Capacity for Normal Oil Change
Low to High Range
75 & 100 HP
10 U.S. Gallons
1.25 U.S. Gallons
Figure 5-8 APPROXIMATE OIL SYSTEM CAPACITIES
Air/oil under pressure will cause severe personal injury or death. Shut down
compressor, relieve system of all pressure, disconnect, lockout and tagout
power supply to the starter before removing valves, caps, plugs, fittings, bolts
and filters.