![background image](http://html1.mh-extra.com/html/gardner-denver/fil-series/fil-series_manual_3574508003.webp)
3
1.0 Installation
A. Where Used/Air Quality After Filtration
Grade
Where used
Solid particle
Liquid removal
Maximum inlet
Remaining oil
removal (maximum efficiency (at rated
liquid loading
content
size in microns)
conditions)
ppm w/w
ppm w/w
A
Separator - downstream of an aftercooler
Point-of-use - where no aftercooler is installed
upstream
B
Separator - downstream of an aftercooler
Point-of-use - where no aftercooler is installed
upstream or as prefilter to refrigerated dryer
C
Prefilter -
• Prefilter to Grade F & Grade E high efficiency filters
Point-of-use - where aftercooler is installed upstream
D
Afterfilter- downstream of a pressure-swing (heatless
desiccant dryer
• Downstream of an Activated Carbon or Desiccant
Tower
E
Prefilter - ahead of desiccant and membrane dryers
Afterfilter
• Downstream of refrigerated dryer
• Downstream of pressure-swing (heatless)
desiccant dryers for finer solid particle removal
• Oil removal at point-of-use
F
Prefilter - ahead of desiccant and membrane
dryers (use after Grade C to reduce liquid and solids
load, prolong element life and ensure filtration
efficiency)
Afterfilter - downstream of refrigerated dryer
G
Afterfilter to Grade E & Grade F for true oil free
applications
---
95% of water
30,000
---
bulk liquids
3
99+% of water
25,000
5
aerosols &
bulk liquids
1
100% of water
2,000
1
aerosols
aerosols
)
1
No liquid should be
No liquid should be
present at inlet
present at inlet
---
0.01
99.99+% of oil
1,000
0.008
aerosols
aerosols
0.01
99.999+% of oil
100
0.0008
aerosols
aerosols
0.01
Removes vapors only
No liquid should
0.003
be present
vapor
B. Piping
1. Before installing, blow out pipe line to remove scale
and other foreign matter.
2. Mounting (Grades A, B, C, E, F) - mount so that inlet
and outlet connections are horizontal (filter bowl
vertical) to ensure proper liquid drainage.
3. Flow Direction - install so that the air flow is in the
direction indicated on filter.
NOTE: Grade D flows from outside to inside of element.
All other grades flow from inside to outside. Observe
flow arrows on unit.
4. Isolation valves and by-pass piping - For ease of
service, isolation and by-pass valves are desirable. In
critical applications, two filters installed in parallel may
be necessary to avoid interruption of air supply.
C. Drain Provisions (Grades A, B, C, E, F) - The bottom of
the pressure vessel is provided with a drain plug for
shipping purposes. Provision for manual or automatic
draining is necessary for proper operation.
Do not attempt to remove drain plug if
the unit is pressurized.
1. Manual Drain - When draining is performed manually
on a regular, periodic basis, a simple (open/shut) valve
may be used to drain the vessel. When draining
manually, the valve should be opened slowly to avoid
rapid depressurization and possible element damage.
2. Automatic Drain - Where regular manual draining is
not performed, an automatic condensate drain
should be used. A variety of drains is available from
the manufacturer.
SMD MODELS
TMD MODELS
1" DRAIN PORT
FILTER
HOUSING
MANUAL
OVERRIDE
22
MIN
SEC
1
7
15
1
45
POWER
ON
ELECTRIC DRAIN