Gardner
Bender
Instruction
Sheet
Electric
Pumps
IMPORTANT: RECEIVING INSTRUCTIONS
Visually inspect all components for shipping damage.
If any shipping damage is found, notify carrier at once.
Shipping damage is NOT covered by warranty. The
carrier is responsible for all repair or replacement
costs resulting from damage in shipment.
IMPORTANT--USER SAFETY AND PROTECTION:
In setting up systems, take care to select
the proper components and design to ensure appropriate integration with your existing operations
and equipment. Observe all safety measures to avoid the risk of personal injury and damage to
property and equipment through improper usage.
GB ELECTRICAL, INC. CANNOT BE HELD RESPONSIBLE FOR DAMAGE OR INJURY
CAUSED BY UNSAFE USE, MAINTENANCE OR APPLICATION OF ITS PRODUCTS. Please
contact GB's technical service department for assistance if you are in doubt as to the proper
safety precautions essential to designing and setting up your particular application.
CLAMP METER
!
Electric
Hydraulic
Voltage
Tester
NEUTRAL
• Check hydraulic oil level in reservoir to
prevent pump failure.
• Start pump with directional valve in neutral
position to prevent accidental lifting or
moving of load.
• Have only qualified personnel check motor
nameplate against power availability to
prevent motor burnout or dangerous
electrical overloading.
• Keep extension cord length to
a minimum and sizes to electric code.
Do not use standard electrical equipment
in an explosive atmosphere. Use
grounded receptacle.
• Adhere to all applicable local and national
electrical codes.
• Do not exceed capacity of equipment
attached to pump. Use a gauge in line
and do not exceed pressure rating of
lowest capacity pressurized component
in the system.
Upon receipt of pump...
1. Remove oil fill plug.
2. Reservoir oil level should be checked
(with all cylinders retracted).
3. If necessary, add ENERPAC hydraulic oil.
CAUTION
:
The use of other fluids may
cause extensive damage to
the pump. Such damage is
not covered by GB Warranty.
4. Replace oil fill plug.
WARNING
:
Pump overload protection is factory
set. Adjustment by other than
qualified personnel may cause
malfunction and/or damage to
component parts of the system.
NOTE
:
Maximum Hydraulic Pressure
generated by this unit is 10,000 PSI.
